Do Klipsch speakers have fuses?

From split LSIs to KP3002s to KP301s, KP 250s, you name it, EVERY single speaker has come with a 20 amp factory test fuse.

What fuse should I use for my amp?

The correct size of fuse to use depends on the amp you are wiring. If your amp has an internal fuse, then your inline car amp fuse should be a bit larger. For instance, if your amp has an internal 20 amp fuse, then you should go for a 25 or 30 amp inline fuse.

What kind of Fuse does a Klipsch subwoofer use?

Whether the factory fuse has any specific specifications I don’t know. Most likely it’s a standard fast blowing glass fuse. There are glass fuses that are called slow blow, time delay fuses such as the Bussman GDC Series, Time-Delay, Glass Tube – GDC-2A.

Where can I find a sub 10 fuse?

The SUB-10 fuse near the power cord, after taking some measurements of the fuse holder appears to use a 5 mm x 20 mm 2.0 amp fuse, which I believe is a fast blowing type. You should be able to find this type of fuse at a Radio Shack, online or possibly at a hardware store.

Can a bash amp be used in a subwoofer?

When trying to diagnose electronics it’s better to start with the fundamentals such as power to the unit, power cord and any fuses. This sub uses a BASH amp, so it’s possible when the only problem is the amp, which I believe (withiout a schematic or service manual) should be a separate pcb.

What should I do if my subwoofer fuse blows?

Fuses don’t just blow, especially in the SUB-10. You might as well start looking for a place to repair it. Most likely a fast blow. Hardware stores usually stock fuses. The manual should tell you the type and size. Fuses don’t just blow, especially in the SUB-10. You might as well start looking for a place to repair it.

What are the fuse specs for a Klipsch subwoofer?

Follow Attached, you will find the fuse specs for the following Klipsch models: GMX A2.1 Sub GMX D5.1 Sub HDT 300 (Sub 6) HDT 500 (Sub 8) HDT 600 (Sub 8 II) iFi Sub KA-1000-THX KSP-400 KSS-3 KSW-10 KSW-12 KSW-15 KSW-100 KSW-150 KSW-200 KSW-300 KSW-50 LF-10 P-312SW R-110SW

The SUB-10 fuse near the power cord, after taking some measurements of the fuse holder appears to use a 5 mm x 20 mm 2.0 amp fuse, which I believe is a fast blowing type. You should be able to find this type of fuse at a Radio Shack, online or possibly at a hardware store.

Why does the fuse keep blowing on my subwoofer?

The fuse blows because there’s a fault in the amp. It’s probably cheaper to replace the amp than fix it, assuming the driver is OK. Click to expand…

How big is the fuse on a subwoofer?

I measure the diameter to be approx. 5 mm. Fuses don’t just blow, especially in the SUB-10. You might as well start looking for a place to repair it. Most likely a fast blow. Hardware stores usually stock fuses. The manual should tell you the type and size. Fuses don’t just blow, especially in the SUB-10.