How do I change the clock on my iPod dock?

How to setup the time/date format on my Philips dock?

1. Press the POWER button to switch the device to Standby mode when it is in active mode.
2. Press and hold the TIME SET/AUTO SCAN button until the hour digits are displayed and begin to blink.
3. Press the TUNING +/- buttons to set the hour.

How do I set the time on my iHome docking station?

Press and Hold the Time Set Button located on the back of the unit until the display flashes. Press the – or + Buttons to adjust the clock to the current time (hold for rapid setting). Make sure you set the correct AM/PM time. The PM indicator appears to the left of the display; there is no AM indicator.

What is sleep mode on iHome clock?

“Sleep mode” lets you fall sleep to your iPhone/iPod or radio, gradually lowering the volume until the unit shuts off at the selected time.

How do you use the iHome dock?

Insert the iPod and iPhone into the dock on top of the iHome. Some iHome devices have two docks, allowing you to charge an iPod or iPhone at the same time. Turn the iHome on and insert the iPod or iPhone into the desired dock. Sync the iPod or iPhone to the iTunes library on your computer.

How do I change my home time?

Press and hold the “Hour Set” button. The current hour will presently be displayed. Press the “Sleep/Minute Set” button to adjust the minute time. If your unit does not contain these buttons, press the “Select UP/FF” or “Select Down/Rew” button until the correct time is displayed.

How do you set the time on a Philips digital clock?

How to setup the clock time on my Philips clock radio?

1. In standby mode, press PROGRAM/SET TIME.
2. Hold down or press HOUR/MIN repeatedly to adjust the hours and minutes.
3. Press PROGRAM/SET TIME to confirm the setting.

How do I set the time on my iHome hpl10?

SETTING THE TIME MANUALLY Press and hold the Time Set Button until “MAN” or “SYNC” flashes in the display with one beep. If “SYNC” is displayed, press the + or – Buttons so “MAN” appears in the display, indicating manual time setting mode. 2. Press and release the Time Set Button.

How do you set a playlist on an iHome alarm?

To do so, you must first create a playlist named “iHome” in iTunes and have it on your iPad/iPod/iPhone. While “DOCK” is displayed, press and release the Alarm Button, then press and release the + or – Button to select “Playlist Wake”. The unit will play music randomly from within the “iHome” playlist.

How do I turn off sleep on my iHome?

How do I turn-off the Sleep function? Press and hold the Sleep Button to end Sleep mode.

How do I set the time on my iHome without the time button?

Press the “Sleep/Minute Set” button to adjust the minute time. If your unit does not contain these buttons, press the “Select UP/FF” or “Select Down/Rew” button until the correct time is displayed. Press the “Time Set” or “Clock Adjust” button again to confirm the clock time setting.

How do I listen to music on iHome?

Connect one end of a standard stereo 3.5mm audio cable (not included) into the line-in jack on the back of your iHome and the other into the headphone or output jack of your audio device. Turn the device on and press play.

What can you do with an old iHome?

Recycle It: If your old device is no longer useful to you or to anyone else, the clear choice is to recycle. Even dead electronics contain certain components that can be harvested and re-used, and can often be done at no cost to you.