How do I reset my Yamaha RX V775?

RX-V775 Setting Receiver Back to Factory Settings

1. Set the unit to Standby Mode using the Main Zone Power button.
2. While holding down the Straight on the front panel, press the Main Zone Power button.
3. When SP IMP -8ohms Min or SP IMP -6ohms Min comes up on the reciever panel, let go of the straight button.

Why does my Yamaha RX v675 have no sound?

I connected just the basics, two speakers (all I have right now), subwoofer (powered), hdmi out and network to try it out, and I’m not getting any sound out of it whatsoever. I’ve tried using the radio, and playing Pandora through the internal app and no matter how much I turn the volume up, I get absolutely zero sound.

Is the Yamaha rx-v675 an AV receiver?

I’ve recently acquired a Yamaha RX-V675 AV Receiver. I connected just the basics, two speakers (all I have right now), subwoofer (powered), hdmi out and network to try it out, and I’m not getting any sound out of it whatsoever.

What does it mean when a Yamaha receiver won’t power on?

My Yamaha receiver RX – V730 won’t power on. I hear a double click when I hit the power button. Seems like it’s turning itself off immediately and in a safety mode of some sort. Any advice before I chalk it up as a loss?

Why is my Yamaha rx-v540 receiver not turning on?

Hi, one of these just landed on my bench, with the same symptoms. Fault turned out to be a bad NJM7805FA regulator, which was showing 0.7 volts on the +5VD2 output. The regulator tested ok when supplied externally, but the output fell under moderate load.

I connected just the basics, two speakers (all I have right now), subwoofer (powered), hdmi out and network to try it out, and I’m not getting any sound out of it whatsoever. I’ve tried using the radio, and playing Pandora through the internal app and no matter how much I turn the volume up, I get absolutely zero sound.

I’ve recently acquired a Yamaha RX-V675 AV Receiver. I connected just the basics, two speakers (all I have right now), subwoofer (powered), hdmi out and network to try it out, and I’m not getting any sound out of it whatsoever.

What should I do if my Yamaha receiver won’t connect to WiFi?

A full reset is pretty painful to do unless you can reload your settings from some known-good ones you previously saved (not familiar with your Yamaha model, save the settings you have now regardless, if you can). But I guess it couldn’t hurt to reset, because a warranty repair (if that’s what is eventually needed) would do that anyway.

How can I Reset my Yamaha 775 AVR?

Resetting on the Advanced Setup menu is the only “reset” option, but… You could try turning OFF the Network Standby option, powering down the AVR, then powering it up. My 775 used to have problems streaming Pandora until I did this.