How to connect vsx-534 pioneer home audio visual?

1. Main unit (1) 2. Remote controller (RC-971R) (1), Batteries (AAA/R03) (2) 3. Speaker setup microphone (1) • Used during Initial Setup. 4. Indoor FM antenna (1) 5. AM loop antenna (1) • Quick Start Guide (1) *This document is an online instruction manual. It is not included as an accessory. • Connect speakers with an impedance of 4 Ω to 16 Ω.

Why does my pioneer VSX receiver stop working?

Hey so I bought a Pioneer VSX receiver about 4 months ago and it suddenly stopped working. The receiver turns on but no sound comes out of the speakers. I plugged in headphones and there was some sound but it wasn’t very loud, even on full volume.

What to do if your remote control is not working?

Have you ever encounter you grab your remote control and turn your appliances on and it doesn’t work you think it’s just a Low Battery situation that it could be FIX, But when you change it it doesn’t work at all and you give up you just toss your remote.

Is the VSX line known to have good performance?

The VSX line (at least from a few years ago) is known to have good performance, but is on the difficult end as far as configuration goes. You must log in or register to reply here.

Why is the remote not working on my pioneer VSX 532?

Pressing that second Receiver button on the remote control fixed it, thank you! Two Receiver buttons next to each other on the remote control is a stupid design choice. You must log in or register to reply here.

Why is my pioneer remote not working on my Yamaha receiver?

Problem on Remote control of Yamaha receiver RX V 475 Solved! Pioneer elite remote only works with vol and power button on ant mode Solved! Pioneer remote 9606 stop working has new battery The volume controls on my Pioneer VSX-820 Remote AXD7583 are not working. The power button and source buttons are working, bu

Can you turn the receiver on or off with the remote?

I cannot turn the receiver on or off with the remote, I cannot change sources like bd,dvd,cd, etc, also I cannot change the volume with the remote could I have acidently set it to something wrong? You have to push the receiver button one down from the top left. Here’s a link to the manual