Is there a problem with my Yamaha ysp-1100 sound bar?

I have suddenly started getting a problem with my Yamaha YSP-1100 soundbar. When the unit has been turned off for some time, if I try turn it on nothing happens. This is either from the remote control or the power button on the front.

What does Yamaha ysp-1100 digital sound projector look like?

The very nature of this system shows that Yamaha is fully capable of combining form and function into a stylistic box that looks as good as it performs. From the blue LCD display on its piano gloss black finish to the silver or black steel grill which covers the 42 drivers, Yamaha’s YSP-1100 is an elegant piece to look at.

Which is better YSP 1100 or YSP-1?

The original YSP-1 was a bit difficult to setup and became a bit of a hassle for non-installers to configure. Manual configuration is still available, of course, but this is a stellar improvement that should be a “Page 1” notation. Build Quality The YSP-1100 is available in either silver or black.

What kind of power does a Yamaha ysp-1000 have?

IT SEEM I HAVE CHANGED THE C515 TO A 22nF 630V INSTED OF A 220nF… THE ORIGINAL C515 CAP HAS THE FOLLOWING PRINTING ON IT : 223 K 630HI…. YOU SURE IT IS A 220nF….??

I have suddenly started getting a problem with my Yamaha YSP-1100 soundbar. When the unit has been turned off for some time, if I try turn it on nothing happens. This is either from the remote control or the power button on the front.

How does the Yamaha ysp-1100 digital sound projector work?

The YSP-1100 employs 40 1.5-inch micro drivers and 2 4.25-inch woofers–each powered by its own digital amplifier–as well as projection technology to control the direction of the sound. It does this by focusing the 1.5-inch drivers’ sound into groups of “beams” that reflect off the room’s walls.

The original YSP-1 was a bit difficult to setup and became a bit of a hassle for non-installers to configure. Manual configuration is still available, of course, but this is a stellar improvement that should be a “Page 1” notation. Build Quality The YSP-1100 is available in either silver or black.

IT SEEM I HAVE CHANGED THE C515 TO A 22nF 630V INSTED OF A 220nF… THE ORIGINAL C515 CAP HAS THE FOLLOWING PRINTING ON IT : 223 K 630HI…. YOU SURE IT IS A 220nF….??

Is the Yamaha YSP 1000 out of warranty?

After about 3-4 months of intermittent failures, i took it back to the shop i bought it from, (which sounds like a place in Kent) and paid £40 for them to investigate the fault. They said that as its out of warranty Yamaha wouldn’t want to know about the fault. 2 weeks later, i got it back in the same condition, broken.

Can a Yamaha sound bar be repaired out of warranty?

I attempted to contact Yamaha UK and enquire about a good-will repair out of warranty but was met with no response.

After about 3-4 months of intermittent failures, i took it back to the shop i bought it from, (which sounds like a place in Kent) and paid £40 for them to investigate the fault. They said that as its out of warranty Yamaha wouldn’t want to know about the fault. 2 weeks later, i got it back in the same condition, broken.

How long does it take to calibrate Yamaha ysp-1100?

The YSP-1100’s streamlined IntelliBeam autosetup and calibration system was a breeze to use. Once we brought up the onscreen menu, plugged in the supplied microphone, the completely automated procedure takes just a few minutes to complete.

How can I Fix my Yamaha sound bar?

Unscrew the silver screws that hold the power board in place and unplug all connectors from the power board so that you can remove it. Take extreme care with the connector highlighted in the picture below — it bridges the power board to the board to the left.

What kind of speakers do Yamaha soundbars have?

In fact the Yamaha soundbar line had changed dramatically and there was a whole new selection available. However I wanted the “older” sort with the dozens of micro-speakers providing the “sound beam” technology and the auto-setup for your room dimensions using a microphone.

What’s the problem with the Yamaha ysp-900 soundbar?

Note that although the AVForums thread is about the YSP-1000, the symptoms are the same and the YSP-900 (and other models) are all mentioned in the thread. The problem, in almost all cases detailed in the thread was a degraded capacitor in the power supply.

In fact the Yamaha soundbar line had changed dramatically and there was a whole new selection available. However I wanted the “older” sort with the dozens of micro-speakers providing the “sound beam” technology and the auto-setup for your room dimensions using a microphone.

How much did it cost to buy a Yamaha sound bar?

Eventually I found a used YSP-900 on eBay which came with a Yamaha subwoofer. It cost £189, which was a lot of money, but a lot less than you’d pay for a new one, especially as it came with the seperate sub. I bought and paid for the YSP-900 and fetched it from the seller.

Unscrew the silver screws that hold the power board in place and unplug all connectors from the power board so that you can remove it. Take extreme care with the connector highlighted in the picture below — it bridges the power board to the board to the left.

What are the features of the ysp-2200 sound bar?

HDMI V.1.4a is the latest version of the HDMI interface, featuring 3D for transmitting 3D video signals. Audio Return Channel lets you hear the TV sound from the YSP-2200 via a single HDMI cable, with no need for an extra optical cable. HDMI also provides the benefits of Deep Colour, x.v.Colour and Auto Lip-Sync.

How does the Yamaha ysp-5600 surround sound system work?

In addition, the YSP-5600 uses the surround channel sound beam for surround back to support 7.1.2-channel Dolby Atmos or DTS:X reproduction. The height channels are created by placing six array speakers on each end of the unit (a total of 12). For the maximum sound beam effect, they are mounted on an angled baffle with sound beam vertical control.

How many Watts Does a YSP-1 woofer use?

The YSP-1 features a pair of 4.5-inch woofers and 40 1.5 inch microdrivers–the woofers have 20-watt amplifiers, and each 1.5-inch microspeaker is powered by its own 2-watt amp. That adds up to a total of 120 digital watts.

HDMI V.1.4a is the latest version of the HDMI interface, featuring 3D for transmitting 3D video signals. Audio Return Channel lets you hear the TV sound from the YSP-2200 via a single HDMI cable, with no need for an extra optical cable. HDMI also provides the benefits of Deep Colour, x.v.Colour and Auto Lip-Sync.

The YSP-1 features a pair of 4.5-inch woofers and 40 1.5 inch microdrivers–the woofers have 20-watt amplifiers, and each 1.5-inch microspeaker is powered by its own 2-watt amp. That adds up to a total of 120 digital watts.

What should I do if my sound bar is not working?

Try and keep the cable clear of other connectors, especially power, in the tangle of wires behind your TV. Simply moving the 3.5mm cable can sometimes solve this issue. If this doesn’t solve the problem, make sure your TV volume is turned all the way up so you can adjust the sound bar’s volume directly.