What does amp error mean on my Pioneer?

This error is specific to the internal amp inside your pioneer deck,either your output wires leaving the radio are touching together somewhere or grounding out somewhere in route to the speakers or your internal IC chip is blown.

What does it mean when your Pioneer Radio Says Error-10?

Re: why is it error-10 on my pioneer? The manual is clear about this. There is a power failure to the bluetooth. If switching off and on (ignition switch) does not help, you should contact a dealer or a repair centre.

What does Error-10 mean on a radio?

PROTECT Bluetooth audio/telephone Message ERROR-10 Cause Built-in Bluetooth unit encountered an error Built-in FLASH ROM encountered an error Action Turn the ignition OFF and ON.

What does Error 10 mean on a Bluetooth radio?

Usually, a Code 10 error is a temporary error, generated when Device Manager can’t start the hardware device. However this error is considered a generic message indicating an unspecified problem. In Device Manager, the properties of the Bluetooth or Wireless device shows status = “This device cannot start.

What to do if your VSX has an amp error?

The learning curve is pretty steep to fix and you would need some test gear too. If it shows amp error even with all speaker wires unconnected, the amp is short. This happens a lot with these VSX, they aren’t exactly solid. I suggest you use an ohmmeter, and check each individual output transistor.

Why did my pioneer VSX 514k go into shutdown mode?

Here we have a very nice Pioneer that was working just fine and then all of a sudden one day when it was powered up it gave the AMP ERR on the display and then went into shutdown mode and wouldn’t power back up. I tried to reset the error but got the same results which means it wasn’t a fluke.

Do you always unplug the AMP on a vsx-514k?

Yes, always unplug the amp for checking transistor shorts and resistances/fused. R51 is a 2.2Megaohm resistor. It’s a very high resistance, and you won’t be able to measure it without the meter being in MΩ. What you are looking for is voltage on the PAC10A or PAC11 (IC601/IC602) ICs.

The learning curve is pretty steep to fix and you would need some test gear too. If it shows amp error even with all speaker wires unconnected, the amp is short. This happens a lot with these VSX, they aren’t exactly solid. I suggest you use an ohmmeter, and check each individual output transistor.

Here we have a very nice Pioneer that was working just fine and then all of a sudden one day when it was powered up it gave the AMP ERR on the display and then went into shutdown mode and wouldn’t power back up. I tried to reset the error but got the same results which means it wasn’t a fluke.

Yes, always unplug the amp for checking transistor shorts and resistances/fused. R51 is a 2.2Megaohm resistor. It’s a very high resistance, and you won’t be able to measure it without the meter being in MΩ. What you are looking for is voltage on the PAC10A or PAC11 (IC601/IC602) ICs.

How to do soft reset on Mercedes Benz no sound?

The fist thing you should try is to do a soft reset of the COMAND unit. To do a reset you will need to remove the fuses for at least 10 min for these systems: By removing the fuses for these systems, you will be forcing the command unit to perform a rest.