What is Denon center spread?

Center Spread expands the center channel signal to left and right front speakers to create a wider frontal audio image for the listener. It is optimized and designed primary for playback of stereo music content.

How do I make my dialogue louder on my surround sound?

Raising the center channel volume relative to the left/right and surround channels makes dialogue louder than the music and sound effects, so it’s easier to understand what the actors are saying. The easiest way to make the adjustment is with your receiver or home theater-in-a-box system’s remote control.

Is the center channel on the Denon avr-519 too low?

I ran through the Audyssey setup on my Denon AVR-519 using all 6 available mic measurement positions, and it sounds fine except that the center channel is WAY too low. I can hardly hear the dialogue when watching movies, yet all the other sound effects are LOUD.

Is the center channel on an AV too low?

The center speaker faces the listener, but is parallel to the ground at about chest level when seated. Got a brand new AV7005 in my hands and after calibration i have the same result as above, center channel is set at 0dB at it is way too low.

Where is the center channel on my speakers?

Center channel is 4,55m from seat pointing into my chest ( not possible to change ) and that can hardly be the root cause ! Anders, do the test chirps sound the same from the center channel as they do from the other speakers? I am not sure what else could be the issue.

Is the center channel too low on Audyssey?

After running the Audyssey set up several times my center channel dialogue output still sounds too low. I have re-measured with an SPL meter, the pink noise out-put is spot on across the board. All calibrations appear to be correct and accurate…distance etc. Speakers are at 80hz and the LPF of the LFE is at 120hz.

I ran through the Audyssey setup on my Denon AVR-519 using all 6 available mic measurement positions, and it sounds fine except that the center channel is WAY too low. I can hardly hear the dialogue when watching movies, yet all the other sound effects are LOUD.

The center speaker faces the listener, but is parallel to the ground at about chest level when seated. Got a brand new AV7005 in my hands and after calibration i have the same result as above, center channel is set at 0dB at it is way too low.

Why is there no sound from the center channel?

There is no audio from center speaker when the system is not in stereo mode. If the system can’t use both terminals A and B at the same time, what use will terminal B have? I hooked up the two main front speakers to terminal A, and one of the three back speakers (6.1 System) to speaker B terminal.

After running the Audyssey set up several times my center channel dialogue output still sounds too low. I have re-measured with an SPL meter, the pink noise out-put is spot on across the board. All calibrations appear to be correct and accurate…distance etc. Speakers are at 80hz and the LPF of the LFE is at 120hz.