Why is the radio in my car not turning on?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there’s one or more blown fuses causing the problem. This can also cause fuses to blow in rapid succession (you replace a fuse and it blows again shortly after).

Why is my Kenwood car stereo not working?

How to troubleshoot a Kenwood KDC-HD548U car stereo installed on a Chevy Silverado through a GMRC-02 Harness kit which has power but does not power up? One of the radio fuses on the vehicle has probably blown because of which the red power switch is not receiving power.

What’s the best way to activate a Kenwood radio?

The best way to activate the radio is to take the car to a dealership. Dealerships have the equipment to generate a code. Why does a Kenwood TK 840 UHF mobile radio, mounted in a truck, not turn on even though it is correctly wired up? Check that the Kenwood is receiving 12 volts and also check that all fuses are good.

Why is my JK radio not working on my Jeep Wrangler?

My 2008 JK radio quit working. It would go off and on but then would not work at all. I took the radio out and check the wiring harness and it is getting power. Put a new radio in and it won’t power on at all. Checked the fuse box and all is good.

What should I look for in a Kenwood radio?

Check that the Kenwood is receiving 12 volts and also check that all fuses are good. If both check out then the radio probably has an internal fault which will need to be repaired at an electronics shop or the unit will have to be replaced. The most common internal issues that TK models suffer from are:

Why is my Kenwood radio not turning on?

Michael, Check the Kenwood trouble shooting links below for radio not turning on. 2nd link talks about the protect mode and how to diagnose why it may be on. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.

My 2008 JK radio quit working. It would go off and on but then would not work at all. I took the radio out and check the wiring harness and it is getting power. Put a new radio in and it won’t power on at all. Checked the fuse box and all is good.

What to do when your radio won’t turn on?

Put a test light across the power leads at the radio. If there is power, and you have a good ground, you either need a new radio or the lead isn’t making good contact t the plug. If not, check for power ar the fuse. If there is power there, the wire is bad between the fuse and the radio.

Where can I get United radio for my Jeep Wrangler?

Here’s the United Radio 5717 Enterprise Parkway East Syracuse NY 13057 1-800-634-8606 Mon-Fri 8:30 AM – 5:30 PM 39 people found this helpful. I have a Jeep JK Wrangler – same problem with the radio.