Why is my pioneer rt-707 reel to reel not working?
Jessica Cortez Why is my pioneer rt-707 reel to reel not working?
The right channel issue was caused by a bad solder joint on the RCA connector. I’ve got this Pioneer RT-707 open reel tape deck back together and it’s about time for some bench testing. This Pioneer RT-707’s transport seems to be functioning well hooked up to the test bench system.
When did the pioneer rt-707 tape recorder come out?
Since 1982. Pioneer RT-707 R2R / reel-to-reel tape recorder replacement parts / spares. Pioneer RT-701 / RT-707 RT701 / RT707 Motors, hubs, spindles, circuit boards, Pioneer RT-707 / 701 rubber pinch rollers, heads, solenoid / solenoids, capstan motor, face plate, meters, relay / relays, brakes, and most other parts.
Where are the play lamps on a pioneer rt-707?
The belt is attached to a groove in the left reel motor and to a pulley on the back of the tape counter on the other. Both of the directional play lamps in this Pioneer RT-707 were burned out. I’ll replace them with LED’s.
What kind of power supply does pioneer rt-707 tape deck use?
Both of the directional play lamps in this Pioneer RT-707 were burned out. I’ll replace them with LED’s. The original lamps in this pioneer reel to reel tape deck ran on 26V DC from the power supply. You can tell from the chart below none of these LED’s are going to be happy with 26 Volts.
The right channel issue was caused by a bad solder joint on the RCA connector. I’ve got this Pioneer RT-707 open reel tape deck back together and it’s about time for some bench testing. This Pioneer RT-707’s transport seems to be functioning well hooked up to the test bench system.
Since 1982. Pioneer RT-707 R2R / reel-to-reel tape recorder replacement parts / spares. Pioneer RT-701 / RT-707 RT701 / RT707 Motors, hubs, spindles, circuit boards, Pioneer RT-707 / 701 rubber pinch rollers, heads, solenoid / solenoids, capstan motor, face plate, meters, relay / relays, brakes, and most other parts.
The belt is attached to a groove in the left reel motor and to a pulley on the back of the tape counter on the other. Both of the directional play lamps in this Pioneer RT-707 were burned out. I’ll replace them with LED’s.
Both of the directional play lamps in this Pioneer RT-707 were burned out. I’ll replace them with LED’s. The original lamps in this pioneer reel to reel tape deck ran on 26V DC from the power supply. You can tell from the chart below none of these LED’s are going to be happy with 26 Volts.
